BOP Series     可程式 4 象限電源供應器

• Full 4-quadrant, 1000 watt,source-sink operation.
• Energy recuperation, during sink-mode, through a bi-directional PFC circuit.
• Power factor greater than 0.97.
• Precision stabilization: 0.001% source, 0.002% load.
• Meets the EN61000-3-2 harmonic limits.
• High efficiency switch-mode operation.
• Output voltage from ±6V to ±100V.
• Optimized for Very Low Ripple and Noise.(BOP 1KW GL Series)
• Full digital control with built-in standard GPIB and RS 232 interface. Understands SCPI and IEEE 488.2; VISA driver provided.
• Fast analog programming.
• Analog control available via external reference.
• Built-in arbitrary waveform (function) generator allows the BOP High Power Models to produce Sine, Triangular, Positive Ramp, Negative Ramp (sawtooth) and Square waveforms directly, without an external signal generator.
• Transient Support. Can be programmed via the GPIB or RS 232 interfaces to create a transient, changing the output for a fixed period and then returning to the original state.
• Can be triggered by external source.
• Can output trigger to synchronize LIST command among multiple units and/or external devices.
• Can sample output voltage or current during LIST command execution.
• Rejection of line-related ripple/noise for 50Hz and 60Hz by changing step change response timing.
• Quick Setup. 99 setups can be stored and recalled; each setup includes operating mode, output on/off, main channel reference type and value, and protection reference type and value.
• Large graphic LCD, displays settings and actual output.
• Keypad control from front panel with menu to access functions.
• Calibration adjustments are made either locally with the keypad or remotely through the GPBI or RS 232 interfaces, and are stored in non-volatile memory. Calibration is password protected.
• CE; Complies with the requirements of the Low Voltage Directive 73/23/EEC and the Marking and Declaration Directive 93/28/EEC and the EMC Directive 89/336/EEC.
• Provides a one-step solution for test and characterization of solar cells and solar panels(Optional : Upgrade Kit 219-0533. )

Solar Device Testing.
The Kepco BOP 1KW provides a one-step solution for test and characterization of solar cells and solar panels: see Kepco Applicaton Note "Using Kepco BOP 1KW for Solar Device Testing". A free LabView subvi allows rapid characterization of the solar device using only the BOP 1KW, eliminating the need for separate DVMs to measure voltage and current. The subvi is designed for both I-V Trace and Dark I-V testing, and can be plugged in or easily adapted to existing LabView test applications. Units with firmware version below 3.05 (find Firmware Version) can be upgraded to have this capability with Upgrade Kit 219-0533.

BOP are CE Marked per the Low Voltage Directive (LVD), EN61010-1 in accordance with the Conditions of Conformance.