klp 系列可程式 4 象限電源供應器

KLP 系列 1U 可程式定電壓、定電流、定功率直流電源供應器

TO->

SPECIFICATIONS		RATING/DESCRIPTION	CONDITION
Stabilizer Type		CV/CC	Voltage/Current
Adjustment Range	voltage	0-100% of rated voltage	No minimum load required
Adjustment Range	current	min-100% of rated current(note.1)	No minimum load required
Source Effect	voltage	0.01% Emax	Over full source range
Source Effect	current	0.01% lmax	Over full source range
Load Effect	voltage	0.01% Emax	Over full load current range
Load Effect	current (note.2)	0.01% lmax (note.3)	Over full load current range
Temperature Effect	voltage	0.02%/°C	0-50°C
Temperature Effect	current	0.05%/°C	0-50°C
Time Effect (drift)	voltage	0.05%/24hr	After 30 minute warmup
Time Effect (drift)	current	0.05%/24hr	After 30 minute warmup
Error Sensing		0.25 volts per wire	Above rated output
Isolation Voltage		600V d-c or peak	Either output terminal to ground
Transient Recovery for Load Change	excursion	1% of Emax	50% load step 2A/μsec max
Transient Recovery for Load Change	recovery	2 msec	Return to 0.1% of setting
Turn on / turn off Overshoot		Same as load transient response limits
Overvoltage Protection	voltage	20-120% of Emax	User selectable recovery
Overcurrent Protection	current	72-120% of Imax	User selectable recovery
Overtemperature Protection		Shutdown	User selectable recovery
Output Lead Fault Protection		Shutdown	User selectable recovery
Parallel Operation		Active load sharing within 5% of I0 rated	Up to 5 units maximum (note.4)
AC Input voltage	nominal	100-240V a-c	Single phase Wide range
AC Input voltage	range	100-255V a-c	Single phase Wide range
DC Input voltage	range	125-420V d-c	No regulatory agency approval
Input Frequency	nominal type	50-60 Hz	Single phase
Input Frequency	maximum	45-440 Hz	Increased leakage above 66 Hz
Power Factor	tpical	0.99	Meets EN 61000-3-2 typical
Maximum Input Current	120V a-c	13A rms	Rated load (1200W)
Maximum Input Current	240V a-c	6.5A rms	Rated load (1200W)
Inrush Current	265V a-c	40A	Peak
Inrush Current	132V a-c	20A	Peak
Input Fusing		Circuit Breaker	2-line
Low a-c Protection		Self Protected	No fixed limits
Output Hold Up	typical	10 milliseconds	Ride through
Leakage Current	115V a-c, 60 Hz	1.2mA max.
Leakage Current	230V a-c, 50 Hz	2.3mA max.
Dimensions		44.45 x 482.6 x 443.7 mm	H x W x D
Weight		6.82kg

note.1 : See Model Table for minimum programmable current.

note.2 : After settling effect.

note.3 : For 600V model: 0.02% + 3.3μA/V of compliance voltage.

note.4 : E-Series models are not Master/Slave capable.

上一頁

下一頁

以上規格及選購配備僅供參考，實際規格以KEPCO網站資料為準，或洽本公司業務人員