| BOP 系列 可程式 4 象限電源供應器 |
| MG 系列規格 : |
| Output | Model | CLOSED LOOP GAIN | OUTPUT IMPEDANCE |
|||||
| CV | CC | VOLTAGE CHANNEL GV (V/V) |
CURRENT CHANNEL GI (A/V) |
VOLTAGE MODE | CURRENT MODE | |||
| V | A | SERIES R (mΩ) |
SERIES L (μH) |
SHUNT R (Ω) |
SHUNT C (μF) |
|||
|
0
- ±6 |
0
- ±125 |
BOP 6-125MG | 0.6 | 12.5 | 0.05 | 1.5 | 24 | 1150 |
|
0 - ±10 |
0 - ±75 |
BOP 10-75MG | 1.0 | 7.5 | 0.13 | 2.0 | 67 | 976 |
|
0 - ±20 |
0 - ±50 |
BOP 20-50MG | 2.0 | 5.0 | 0.40 | 8.3 | 200 | 371 |
|
0
- ±25 |
0
- ±40 |
BOP 25-40MG | 2.5 | 4.0 | 0.63 | 15.8 | 313 | 165 |
|
0
- ±36 |
0
- ±28 |
BOP 36-28MG | 3.6 | 2.8 | 1.30 | 25 | 640 | 103 |
|
0
- ±50 |
0
- ±20 |
BOP 50-20MG | 5.0 | 2.0 | 2.50 | 50 | 1250 | 55 |
|
0 - ±72 |
0 - ±14 |
BOP 72-14MG | 7.2 | 1.4 | 5.14 | 104 | 2570 | 33 |
|
0
- ±100 |
0
- ±10 |
BOP 100-10MG | 10.0 | 1.0 | 10.0 | 163 | 5000 | 16 |
| ● NOTE: When connecting active loads, the steady-state voltage of the active load must not exceed the maximum voltage rating of the BOP. Otherwise the overvoltage protection will shut down the power supply. |
| GL 系列規格 : |
| Output | Model | CLOSED LOOP GAIN | RIPPLE AND NOISE |
|||
| CV | CC | VOLTAGE CHANNEL GV (V/V) |
CURRENT CHANNEL GI (A/V) |
VOLTAGE MODE | CURRENT MODE | |
| V | A | |||||
|
0
- ±10 |
0
- ±100 |
BOP 10-100GL | 1.0 | 10.0 | 0.02% | 0.01% |
|
0 - ±20 |
0 - ±50 |
BOP 20-50GL | 2.0 | 5.0 | 0.02% | 0.01% |
|
0 - ±50 |
0 - ±20 |
BOP 50-20GL | 5.0 | 2.0 | 0.02% | 0.01% |
| ● NOTE: When connecting
active loads, the steady-state voltage of the active load must not exceed
the maximum voltage rating of the BOP. Otherwise the overvoltage protection
will shut down the power supply.
For other Volt-Ampere combinations, please consult factory. |
| 選購配備 訂購訊息： | |
| 編號 | 品名 |
| Line Cord Set 118-1087 | 250V/20A, provides connection to a-c mains via Nema 6-20P connector |
| Line Cord Set 118-1088 | 250V/20A, provides connection to a-c mains via Nema L6-20P locking type connector |
| 142-0527 | Mating Connector, Trigger Port |
| 142-0485 | Mating Connector, IEEE 1118 (BITBUS) Port |
| SNC 488-1 | IEEE 488 (GPIB) Cable (1 meter) |
| SNC 488-2 | IEEE 488 (GPIB) Cable (2 meters) |
| SNC 488-4 | IEEE 488 (GPIB) Cable (4 meters) |
| 142-0449 | Mating Connector, Analog Input Port: (D-Subminiature Connector, 15 Pins, Male |
| 108-0374 | Hood for 15-pin D-Subminiature Connector |
| CS 04 | Chassis Slides |
| KIT 219-0449 | 2 units in parallel, increase current |
| KIT 219-0446 | 3 units in parallel, increase current |
| KIT 219-0447 | 4 units in parallel, increase current |
| KIT 219-0448 | 5 units in parallel, increase current |
| KIT 219-0443 | 2 units in series, increase voltage |
| KIT 219-0444 | 3 units in series, increase voltage |
| KIT 219-0480 | 2 x 2: 2 parallel branches of 2 series-connected units |
| KIT 219-0481 | 3 x 2: 2 parallel branches of 3 series-connected units |
| RS 232 KIT 219-0436 | Contains RJ11 to RJ45 Patch cord, RJ 45 Patch cord, two RS 232 adapters (one w/male pins for DTE equipment, one w/female pins for PC) and two RS 232 Loop Back test Connectors (one 6-pin and one 8-pin) |
| |
|||
| 以上規格及選購配備僅供參考，實際規格以KEPCO網站資料為準，或洽本公司業務人員 |
|||
| |
|||
| Copyright 2024 CHYNG HONG ELECTRONIC CO., LTD. | Contact us |
|||